Drill Press Table (version 1)

This table really isn't a jig but aligns with utility that jigs are built for.  This is a simple setup.  As you can see I had to make a modification in order for the arm of the drill press to swing freely.  I liked the idea for just cutting out a hole for a replaceable waste pad.  After buying a new drill press, I believe I will built a "version 2" where the fence will better accommodate the arm swing and put a T-track low on the vertical side of the fence.  I could also improve on how the table mounts.  I just used simple screw and washer to hold it on this one.

Tuesday 18th of February 2020 -  Copyright 2016 Allan Wolfe